衡水威埃姆除尘器的安装和调试详细介绍

1．设备起吊时，应注意避免碰损箱体及配件。 The lifting of the equipment should be taken to avoid collision damage box and accessories.

2．安装前对除尘器各部件进行全面检查，零部件是否完好齐全，如发现缺少，损坏或变形者，要修整补齐后方可安装。Conduct a comprehensive inspection before installation of various parts of the precipitator parts is intact complete, such as missing, damage or deformation to be installed trimmed padded.

3．灰斗、箱体等各法兰之间应嵌入密封填料才能拧紧螺栓，防止漏气。Tighten the bolts should be embedded in the seal packing to prevent leakage between the flange of the ash bucket, box.

4．各入孔、检查门等处均应有密封嵌条，以保证其密封性。Each into the hole, check the door, etc. should be sealed moldings, to ensure tightness.

5．滤袋要逐条检查，上口一定要绑扎牢，如有脱落现象立即进行修整。The filter bag To check one by one, catchy must lashing prison, if any shedding immediately be trimmed.

6．喷吹管固定后，其喷孔应对准文氏管中心。The blow tube fixed orifice should be aligned with the venturi center.

7．气包、电磁脉冲阀喷吹管的连接应可靠密封，不得有漏气现象。Air bag, electromagnetic pulse valve blow tube connection should be reliable seal, no leak.

8．除尘器进风口、出风口管道上，连通U型压力计测量阻力。根据阻力上升情况，确定喷吹管间隔时间，保证设备正常运行。Precipitator inlet and outlet pipes on the connectivity of U-shaped manometer measurement resistance. According to the resistance increases, determine the injection pipe interval, to ensure the normal operation of the equipment.

9．喷吹用压缩空气应去污除油，压缩空气在接入除尘器气包前应设油水分离器（G3/4"）。 Blowing with compressed air should decontamination degreasing, oil and water separation device (G3 / 4 ") compressed air should be set before access precipitator air bag.

备注：本站价格仅供参考，具体报价请咨询客服

企业网址：http://www.chinawam.com/

邮箱：lvxinnet@163.com
传真：0316-6122099